Resetting The Navigator To Zero; Presetting (Programming) The Odometer - VDO Cyclecomputing MC1.0 Instruction Manual

Table of Contents

2.7.2 Resetting the NAVIGATOR to zero

Step 1:

MODE 2 calls NAVIGATOR into display

Step 2:

Press MODE 2 for 3 sec., the value indicated is being reset to zero. Your VDO MC 1.0 will be counting on from zero.

Warning:

Before resetting to zero, make sure the information NAVIGATOR is called in. If NAVIGATOR is not in the display, you are accidentally re-setting

other information to zero.

After a battery change, you can re-enter previous odometer values (for both bikes) into your VDO MC 1.0.

Step 1:

With MODE 2 call "ODO1 METER" or "ODO2 METER" into display, depending which one of these values you want to re-enter.

Step 2:

Press MODE 1 for 3 sec. The lower part of the display alternately shows "ENTER ODO1 METER" or "ENTER ODO2 METER" plus the respective

value with the last number flashing.

Step 3:

With MODE 2 you increase the number, with MODE 1 you jump to the next number etc.

Step 4:

Once you have entered your values for ODOMETER 1 and ODOMETER 2, you exit set-up mode by pressing MODE 1 for 3 sec.

1.0

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the MC1.0 and is the answer not in the manual?