Ione Series H5 Disassembly - Cybernet i-One Series H5 User Manual

CYBERNET LCD-PC i-One Series H5

iOne Series H5 Disassembly

ORIENTATION: Presumes the top of the iOne is away from you and the bottom or I/O
controller board is nearest you.
Place the iOne face down on a padded surface.
Remove the four screws from the base plate that attaches the stand to the LCD
supporting the base while removing the last screw.
Remove the eleven back bezel screws.
Carefully remove the back bezel and set aside.
Then remove the metal EMI shield by first removing the I/O cover by removing the three
screws on the bottom and four screws on the face. Lift the plate out and up and set aside.
Remove the remaining eleven screws around the metal shield covering the motherboard.
First lift the metal shield and slide it to the right clearing the optical drive door (at the top
right) then disconnect the system fan cable connector from the motherboard at CPU
FAN1 next to the top right corner of the CPU.
System Assembly Page 13