Sharp HT-CN550DVW3 Operation Manual page 20

Change the system with conventional TV connecting
If you use a conventional TV, you must select the INTERLACE at "Video Setup Page" (see page 21).
INTERLACE mode is use for normal video output.
For conventional TV connection, please refer to page 13.
Change the system to a TV with Progressive-Scan
If you use TV with Progressive-Scan capability and connect it to the COMPONENT VIDEO OUT sockets of the DVD main unit (see page 14), you must select the
PROGRESSIVE-SCAN (P-SCAN).
Setup menu Selectable parameters (* indicates default setting)
GENERAL
SETUP
PAGE
AUDIO
SETUP
PAGE
(*1)
Selects the dynamic range compression to fit the individual listening situation of the audience. This function can be used in DVD playback.
Depending on the disc, sounds may become too loud or inaudible during playback. Dolby Digital's dynamic range control allows you to adjust the sound range.
TV DISPLAY NORMAL/PS*
NORMAL/LB
WIDE
WIDE SQUEEZE
ANGLE MARK ON*
OFF
OSD LANG ENGLISH*
RUSSIAN
FRENCH
SPANISH
SCREEN ON*
SAVER
OFF
LAST ON
MEMORY
OFF*
SPEAKER TEST TONE ON
SETUP OFF*
DOLBY DYNAMIC(*1) FULL
DIGITAL
3/4
SETUP
1/4
OFF*
CHANNEL
DELAY
Description
The screen mode should be set according to the connected TV type (for
details, see page 23).
You can select the desired OSD (On Screen Display) language for the
setup menu or playback control screen.
A screensaver appears.
The screensaver is disabled.
If accidently push ON/STAND-BY or OPEN/CLOSE button during
playback mode, you can resume playback from the point playback is
stopped after power on back or you push the OPEN/CLOSE button to
close the disc tray.
Last memory not function.
You can check speaker output (see page 47).
Audio with fully compressed dynamic range.
Audio with partially compressed dynamic range.
Audio with uncompressed dynamic range.
Adjust the delay time of the speakers (for details, see page 46).
HT-CN550DVW3
ENGLISH
E-20