Care And Cleaning - Sharp R-880D Operation Manual And Cooking Manual

CARE AND CLEANING

CLEAN THE OVEN AT REGULAR INTERVALS
IMPORTANT:
Disconnect the power supply cord before cleaning. And if possible leave the door open to inactivate
the oven during cleaning.
Before cleaning, make sure the oven door, outer cabinet, oven cavity, ventilation openings,
turntable, turntable support and racks are not hot.
Exterior:
The outside may be cleaned with mild soap and warm water; wipe with a soft cloth.
Avoid the use of harsh abrasive cleaners.
Door:
Wipe the door (including both sides of the door window and the door seals surface) and adjacent parts
frequently with a damp cloth to remove any spills or spatters. Do not use abrasive cleaner.
Touch Control Panel:
Care should be taken in cleaning the control panel. Wipe the panel with a cloth dampened slightly with
water only. Do not scrub or use any sort of chemical cleaners. Avoid the use of excess water.
Interior walls:
Wipe spatters and spills with a little dishwashing liquid on a soft damp cloth for hygienic reasons. For
heavier stains inside the oven cavity only, use a mild stainless steel cleaner applied with a soft damp
cloth. Do not apply to the inside of the door. Wipe clean ensuring all cleaner is removed. After use wipe
the waveguide cover in the oven with a soft damp cloth to remove any food splashes. Built-up splashes
may overheat and begin to smoke or catch fire. Do not remove the waveguide cover. You can hold the
bottom heater up by hand for cleaning only. After cleaning, sit the bottom heater down in the lowest
position (see page E-4 and Figure 1).
DO NOT USE CAUSTIC CLEANERS, ABRASIVE OR
HARSH CLEANSERS OR SCOURING PADS ON YOUR
OVEN. NEVER SPRAY OVEN CLEANERS DIRECTLY
ONTO ANY PART OF YOUR OVEN. DO NOT USE A
STEAM CLEANER.
NOTE
At regular intervals, heat the oven referring to "Heating
without Food" on page E-6. Because, the splashed dirt
or food oil remained around the top and bottom
heaters oven walls may cause the smoke and odour.
Turntable/Turntable Support/Racks:
Wash with mild soapy water and dry thoroughly.
E – 44
Bottom heater
Figure 1