Table of Contents
Advertisement
Disable Wireless
LAN Interface
Band
Mode
Network Type
Network Name
(SSID)
Check to disable the wireless function. If the wireless LAN
interface be disabled, the WLAN LED on the top will be off.
You can choose one mode of the following you need. The default
is
2.4GHz (B+G+N) mode.
2.4GHz (B): 802.11b supported rate only.
2.4GHz (G): 802.11g supported rate only.
2.4GHz (N): 802.11n supported rate only.
2.4GHz (B+G): 802.11b supported rate and 802.11g
supported rate.
2.4GHz (G+N): 802.11g supported rate and 802.11n
supported rate.
2.4GHz (B+G+N): 802.11b, 802.11g and 802.11n supported
rate.
Under Router operation mode, user can select AP, WDS, and
AP+WDS from the pull-down list. For AP mode, user can select
AP, Client, WDS and AP+WDS mode. Under Client mode, there
is only Client mode can be selected.
Multiple APs
This page shows and updates the wireless setting for multiple
APs
User can set up the multiple AP here. To enable one of the APs
from 1~4, then setup the wireless settings from the pull-down list.
If the mode be set to Client mode that the network type can be set
to Infrastructure or Ad hoc.
A SSID is referred to a network name because essentially it is a
name that identifies a wireless network(case-sensitive).
20
4. Web Configuration
AirLive N.MINI User's Manual
Advertisement
Table of Contents
