Table of Contents
Advertisement
Gigaset SX670_SX675 isdn / EN-Master / A31008-xxxx-xxxx-x-xxxx / appendix.fm / 7.11.07
Appendix
Care
¤
Wipe the base station, charging cradle
and the handset with a damp cloth (do
not use solvent) or an antistatic cloth.
Never use a dry cloth. This can cause a
build up of static.
Contact with liquid
If the handset should come into contact
with liquid:
1. Turn the handset off and remove the
batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us at
www.siemens.com/gigasetcustomercare
at any time. The table below contains a list
of common problems and possible solu-
tions.
The display is blank.
1. The handset is not switched on.
!
2. The battery is flat.
"Fault!" or "Not possible!" appears in the dis-
play.
ISDN jack may not be plugged in.
£
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
"Base station x" flashes on the display.
1. The handset is outside the range of the base
2. The handset has been de-registered.
3. The base station is not turned on.
"Base Search" flashes in the display.
The handset is set to
tion is turned on or within range.
¥
¥
¥
Press and hold the end call key
¥
Charge or replace the batteries (page 8).
Plug in the ISDN jack.
Press and hold the hash key
station.
¥
Move the handset closer to the base sta-
tion.
The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (page 13) or
reduce the distance between the hand-
set and the base station.
¥
Register the handset (page 49).
¥
Check the base station's mains adapter
(page 8).
Best Base
Move the handset closer to the base station.
Check the base station's mains adapter
(page 8).
a
.
#
(page 10).
and no base sta-
69
Advertisement
Table of Contents
