Setting Up The Handset For Use - Siemens Gigaset SX670 isdn User Manual

Gigaset SX670_SX675 isdn / EN-Master / A31008-xxxx-xxxx-x-xxxx / starting.fm / 7.11.07
First steps
Connecting the base station
¤
First connect the mains unit and then
the phone jack as shown below and
place the cables in the cable recesses.
1
1
1
1
1 Mains adapter 230 V
2 Phone jack with phone cord
Please note:
The mains adapter must always be con-
nected, as the phone will not operate
without mains connection.
8
Gigaset SX670 isdn
Gigaset SX675 isdn

Setting up the handset for use

Inserting the batteries
2
Warning:
Use only the rechargeable batteries recom-
mended by Siemens (page 71). Never use a
conventional (non-rechargeable) battery or
other battery types as this could result in sig-
nificant health risks and personal injury. For
example, the batteries could explode. The
phone could also malfunction or be damaged
as a result of using batteries that are not of the
recommended type.
2
¤
Insert the batteries the right way round
(see figure).
The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤
First, align the protrusions on the side
of the battery cover with the notches
on the inside of the housing.
¤
Then press the cover until it clicks into
place.
The display is protected by
a plastic film. Please
remove the protective
film!