ECO DECT reduces power consumption by using a
power supply with low power consumption and
also reduces the transmission power of the base
The transmission power of the base station is swit-
ched off when just 1 handset is registered on the
Your handset also reduces the transmission power
depending on the distance to the base station.
Setting up the telephone for use
Step 1: Connecting the base station
Base station without answering machine
Base station with answering machine
First connect the mains unit (230 V) to power
and then connect the phone jack to phone
, as shown above. Place the cords in the cord
recesses. The two cords must be plugged in at all
Only use the mains unit supplied.
If you ever purchase another phone cord from
a store, ensure that the phone conductors are
correctly connected: 3-4 connection of the tele-
phone conductors/EURO CTR37.
Step 2: Setting up the handset
The display is protected by a plastic film.
Please remove the protective film!
Fitting the battery pack
Place the battery leads in the cable guides so
that the battery cover cannot catch on the leads
and damage them when it is closed.
Use only the rechargeable battery pack rec-
ommended by Siemens (page 9), i.e. never use
a conventional (non-rechargeable) battery pack
as this may cause significant damage to health
and property. For example, the outer casing of the
battery pack could be destroyed or the battery
pack could explode. The phone could also mal-
function or be damaged as a result of using batter-
ies that are not of the recommended type.
Never use non-Siemens battery chargers as
this could damage the battery pack.
Only place the handset in the charging cradle
that is intended for it.
Insert the plug into the socket as shown in the
Insert the battery pack.
Place the cords in the cord routing.