1–2 BEFORE DRIVING YOUR CAR
RUNNING-IN PERIOD
There are no particular brake-in rules for
your new Rexton. However, following a few
simple precautions for the first few thou-
sand kilometers can add to the good future
performance, economy and long life of your
Rexton.
•
Do not race the engine.
•
While driving, keep your engine speed
(RPM) below the red zone.
•
Avoid full-throttle starts.
•
Avoid hard stops, except in emergencies.
This will allow the breaks to bed in prop-
erly.
•
Drive at varying speeds, trying not to
"strain" the engine.
•
Refrain from towing a trailer or an other
vehicle.
•
Avoid harsh operations such as abrupt
start, sudden acceleration and prolonged
high speed driving.
These operations not only have a detri-
mental effect on the engine but also
cause excessive fuel and oil consump-
tion, which could result in the malfunc-
tion of the engine components.
Especially, avoid full-throttle acceleration
in low gear.
BEFORE ENTERING THE CAR
•
Ensure that windows, outside rear view
mirrors and lights are clean, undamaged
and unobstructed.
•
Visually note inflation condition of tyres.
•
Check that all lights, switches and con-
trols work properly.
•
Check the area behind the vehicle if you
are about to reverse.
•
Check under the vehicle for leaks.
•
Check the engine oil level and other fluid/
oil levels in engine compartment.
BEFORE DRIVING OFF
•
Be sure you understand your car and
its equipment and how to operate it
safely.
•
Adjust your seating position.
•
Adjust inside and outside mirrors.
•
Ensure that all occupants of the car
have fastened their seat belts.
•
Check the operation of the warning
lights when the ignition key is turned to
"ON" position.
•
Check all gauges.
•
Release the parking brake and ensure
that the brake warning light goes out.
WARNING
Check to ensure that all light, signal-
ing systems and warning indicators
are in working order.
Need help?
Do you have a question about the REXTON and is the answer not in the manual?
Questions and answers