Learn Function - Medion Remote Control Manual

LEARN FUNCTION

The universal remote control provides you with the possibility of manually
storing certain special functions which have not been stored, or even
devices which have not been included in the code list. To do this, the
original remote control of your device is required in any case. However,
please note the following tips beforehand in order to avoid any mistakes.
• Use new batteries for both remote controls.
• You can assign one remote control to each of the MODE keys.
• Place the remote controls with the infrared diodes on a table so that they
point each other at a distance between 15 and 50 mm.
• You can store up to 150 commands. When the memory is full, the
backlight illumination of the MODE key will be flashing for 3 seconds.
• Each programming of a key can take approx. 3 seconds.
• If you want to programme an additional function to an existing code, verify
in advance which key has not yet been allocated and is still free for
programming.
• The following keys cannot be programmed with functions: LEARN,
SETUP, ALL OFF, MACRO, SHOWVIEW and all MODE keys.
• First have a try by programming any desired code and testing it then.
Thereafter, delete all codes and proceed with the proper programming.
Do not use the learn function beneath an energy saving lamp.
10