Programming The Device Codes - Medion Remote Control Manual

PROGRAMMING THE DEVICE CODES

The codes of the respective devices can be found in the code list attached
to these operating instructions. Proceed as follows:
1. Switch on the respective device manually.
2. Keep the SETUP key pressed for approx. 3 seconds until the backlight
illumination of the MODE keys flashes shortly and then lights up
1
steadily. (By briefly pressing the "SETUP" key, you activate the
SHIFT function.)
3. Release the SETUP key.
4. Briefly press the desired mode key (TV, VCR, DVD, SAT, DSAT, CD,
CBL, AUX)
5. Enter the e-digit code from the code table; the MODE key will flash
shortly for confirmation each time you press a key.
6. If the code entered is the right one, the MODE key will go out when
the last digit has been entered. If an invalid code is entered, the MODE
key will flash for three seconds before going out. – The direct transfer
of the code for your device has now been completed.
Should the device not respond as you expect it to do, you can try to
repeat the programming using another code. Please try all the codes
indicated for your brand. Select the code that makes your device
respond correctly to any command available on your remote control!
If you failed this way, then have another try with the search method
described in the chapter "Automatic code search".
1. The MODE key that will light up is always the key you have
pressed last. When using the device for the first time, the TV
MODE key will be illuminated.
2. The key designations are only meant as a hint to you. You can
assign any desired device to any key ("Flex-Mode").
2
.
5