Automatic Code Search - Medion Remote Control Manual

Automatic code search

Should your device not respond to the remote control although you have
tried all codes listed for your type of device and its brand, try the automatic
search. This allows you to find even codes of brands that are not stated in
the device code list.
1. Switch on the device (TV, VCR, etc.) manually which you want to
operate.
2. Keep the SETUP key pressed for approx. 3 seconds until the backlight
illumination of the MODE keys flashes shortly and then lights up
steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT
function)
3. Release the SETUP key.
4. Briefly press the desired mode key TV, VCR, DVD, CD, SAT, AUX.
5. Point the remote control at the device and press the CHAN+ key once
briefly.
If the device does not possess a channel function, then press the
PLAY or POWER key instead of CHAN+.
After 6 seconds, the remote control will start the code search and
successively send all codes at one second intervals (also see the next
section). When sending, the MODE key will light up each time.
6. As soon as the device does respond to the remote control, press the
OK key. – Should you fail to press the OK key in time, you can step by
step return to the code to which the device has responded using the
CHAN- key.
1-second or 3-second intervals
If you want the remote control only to send a new code every 3 seconds
instead of every second, proceed as follows:
After you have pressed the CHAN+ (or PLAY or POWER) key as
described in section 5, press the CHAN+ key (search forwards) or CHAN-
(search backwards) another time within 6 seconds. Now, the remote
control will send new codes only at intervals of 3 seconds. This will give you
more time, but the procedure will also take longer.
7