Installing The Heat Sink(S); Installing The Heat Sink - MAXDATA PLATINUM 500 I M6 System Manual

Installing the Heat Sink(s)

The heat sink has Thermal Interface Material (TIM) located on the bottom of it. Use caution when
you unpack the heat sink so you do not damage the TIM.
1. Set the heat sink over the processor, lining up the four captive screws with the four posts
surrounding the processor.
2. Loosely screw in the captive screws on the heat sink corners in a diagonal manner.
Do no fully tighten one screw before tightening another.
3. Gradually and equally tighten each captive screw until each is firmly tightened.
4. Reinstall and reconnect any parts you removed or disconnected to reach the processor
sockets.
5. Replace the server's cover and reconnect the AC power cord. See the documentation that
came with your server chassis for instructions on installing the server's cover.
MAXDATA Server PLATINUM 500 I M6 MAXDATA Server PLATINUM 500 I M6
3
2
4
Figure 11. Installing the Heat Sink
1
17 17