01
Before you start
Chapter 1
Before you start
Checking what's in the box
Please check that you've received the following
supplied accessories:
• Remote control
• Dry cell batteries (AA/R6) x2
• Video cable
• AM loop antenna
• FM antenna
• Power cord
• Non-skid pads
• These operating instructions
Loading the batteries
Use AA/R6 batteries with the supplied remote
control. Make sure to follow the indications ( ,
) inside the compartment.
Important
Incorrect use of batteries may result in such
hazards as leakage and bursting. Observe the
following precautions:
• Never use new and old batteries together.
• Insert the plus and minus sides of the
batteries properly according to the marks
in the battery case.
• Batteries with the same shape may have
different voltages. Do not use different
batteries together.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction's rules
that apply in your country or area.
6
En
Range of the remote control unit
The remote control has a range of about 7
meters. It may not work properly if:
• There are obstacles between the remote
control and this unit's remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• This system is located near a device that is
emitting infrared rays.
• This unit is operated simultaneously with
another infrared remote control unit.
Attaching the non-skid pads
Use the self-adhesive non-skid pads to provide
a stable base for the speakers. Attach four to
each speaker as shown below.
Removing the speaker grilles
If necessary, the speaker grilles can be
removed as described below.
1
Gently ease the grille loose by gripping
the bottom and pulling towards you.
2
Pull the top free in the same way.
When reattaching, start from the top then push
the bottom in until secure.
• It is not recommended (due to dirt and
dust) to leave the speaker grilles removed.
• Since the speaker grilles may come loose,
make sure to place the speakers in a
location where they will not cause injury.