Connecting The Radio Antennas; Connecting External Antennas - Pioneer S-HA5 Operating Instruction

02 Connecting up

Connecting the radio antennas

Connecting the supplied antennas will allow
you to listen to both AM and FM radio
broadcasts. If you find that reception quality is
poor, an outdoor antenna should give you
better sound quality—see Connecting external
antennas below for more on how to do this.
fig. a
3
ANTENNA
4
1
1 Pull off the protective shields of both AM
antenna wires.
2 Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
3 Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. a) then
clip the loop onto the stand (fig. b).
Note
1 The signal ground ( ) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety
ground.
8
En
fig. b fig. c
5
AM FM
LOOP ANTENNA UNBAL 75
2
• If you plan to mount the AM antenna to a
wall or other surface, secure the stand with
screws (fig. c) before clipping the loop to
the stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface
and point in the direction giving the best
reception.
Don't let it come into contact with metal
objects and avoid placing near computers,
television sets or other electrical appliances.
5 Connect the FM wire antenna in the same
way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don't drape
loosely or leave coiled up.

Connecting external antennas

External AM antenna
Use 5–6 meters of vinyl-insulated wire and set
up either indoors or outdoors. Leave the AM
loop antenna connected.
Outdoor antenna
Indoor
antenna
(vinyl-coated
wire)
5–6m (15–18 ft.)
External FM antenna
Use a PAL connector to hook up an external
FM antenna.
PAL connector
ANTENNA
AM
LOOP ANTENNA
AM
LOOP ANTENNA
FM
UNBAL 75
1