Using the timer
Setting the record timer
You can set the timer to record from the LINE
source, or something off the radio. For
example, you might want to record a program
that is broadcast while you're at work.
1
Set up the tape deck.
Load a cassette tape, wind on past the leader
tape and set the reverse mode (see Making tape
recordings on page 35 for more on this).
2
Select the source you want to record.
Press TUNER (FM/AM) or LINE and prepare
2
the source.
3
Press TIMER twice, use
'REC?' then press ENTER .
4
Use
to select EDIT then press
ENTER .
5
Set the switch-on time.
Use
to set the hour, then press ENTER.
Set the minute in the same way, pressing
ENTER when you're done.
6
Set the switch-off time.
Set as above, pressing ENTER when done. The
REC indicator lights, then the switch-on,
switch-off times and the function (or
frequency, if you selected the tuner) are
confirmed in the display.
7
Switch the system into standby mode.
The record timer will not work if the system is
left on!
Turning the record timer on/off
If you have already set the record timer, you
can switch it on/off by selecting REC ON or
REC OFF in step 4 above (press ENTER).
Note
1 • During the actual recording, the volume is automatically set to minimum. After the recording has finished, the record timer
is canceled.
• You cannot have the record timer and the wake-up timer set at the same time.
2 For example, if you select the tuner, tune in the station you want to record (see Listening to the radio on page 20).
1
to select
13
41
En