Connecting External Antennas; Connecting To Your Tv; Connecting Using The Component Video Output - Pioneer EV-5DVD Operation Instruction Manual

Connecting up
1 Pull off the protective shields of both AM
antenna wires.
2 Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
3 Fix the AM loop antenna to the stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. a) then
clip the loop onto the stand (fig. b).
• If you plan to mount the AM antenna to a
wall or other surface, secure the stand with
screws (fig. c) before clipping the loop to
the stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface
and point in the direction giving the best
reception.
Don't let it come into contact with metal
objects and avoid placing near computers,
television sets or other electrical appliances.
5 Connect the FM wire antenna in the same
way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don't drape
loosely or leave coiled up.

Connecting external antennas

External AM antenna
Use 5 to 6 meters of vinyl-insulated wire and set
up either indoors or outdoors. Leave the AM
loop antenna connected.
Outdoor antenna
Indoor
antenna
(vinyl-coated
wire)
5 m to 6 m
Note
1 The signal ground ( ) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety
ground.
2 The component video output is switchable between interlaced and progressive formats. See Video Output settings on page 44.
External FM antenna
Use a PAL connector to hook up an external
FM antenna.

Connecting to your TV

This system offers three types of video
connections. If your TV has component video
inputs, see Connecting using the component
video output below.
1
1 connect the VIDEO OUT jack to a video input
on your TV.
2
connect the audio outs of your TV (or VCR) to
the LINE IN jacks on the rear of this unit.
This will enable you to hear the TV (or VCR)
sound through this system. See Connecting
auxiliary components below for more on this.
Connecting using the component
video output
If your TV has component video inputs, you can
use these instead of the standard video output
ANTENNA
to connect this system to your TV.
AM LOOP
ANTENNA
give you the best quality picture from the three
FM
types of video output available.
UNBAL
75Ω
ANTENNA
AM LOOP
ANTENNA
FM
UNBAL
75Ω
Use the supplied yellow video cable to
Optionally: Use a stereo audio cable to
02
PAL connector
2
This should
11
En