Table of Contents
Advertisement
TG8200_8220FX(e-e).book Page 49 Monday, August 6, 2007 5:25 PM
Problem
Cause & solution
I cannot make or
L The base unit AC adaptor or telephone line cord is not
receive calls.
L If you are using a splitter to connect the unit, remove
L Disconnect the base unit from the telephone line and
L The dialling mode setting is incorrect. Set to "Tone" or
L You dialled a call restricted number (page 26).
L The key lock feature is turned on. Turn it off (page 17).
The unit does not ring.
L The ringer volume is turned off. Adjust the ringer
L The night mode feature is turned on. Turn it off (page
The batteries should
L Clean the charge contacts and charge again (page
be charging but the
battery icon does not
change.
A busy tone is heard
L The handset is too far from the base unit. Move closer
when {C} is pressed.
L Another handset is in use or the answering system is
Static is heard, sound
L Place the handset and the base unit away from other
cuts in and out.
Interference from other
L Move closer to the base unit.
electrical units.
L Your unit is connected to a telephone line with DSL
Noise is heard during a
L You are using the handset or base unit in an area with
call.
The handset/base unit
L Disconnect the base unit AC adaptor and turn off the
stops working while
being used.
The handset beeps
L Fully charge the batteries (page 11).
intermittently and/or )
flashes.
connected. Check the connections.
the splitter and connect the unit to the wall socket
directly. If the unit operates properly, check the splitter.
connect the line to a known working telephone. If the
working telephone operates properly, contact our
service personnel to have the unit repaired. If the
working telephone does not operate properly, contact
your service provider/telephone company.
"Pulse" as needed (page 13).
volume (page 21, 25).
23).
12).
and try again.
being used. Wait and try again later.
electrical appliances.
service (page 52).
high electrical interference. Place the handset and
base unit away from interference sources, such as
antennas and mobile phones.
handset. Connect the base unit AC adaptor, turn on
the handset and try again.
Useful Information
49
Hide quick links:
Advertisement
Table of Contents
