Multi-Unit Operation; Operating Additional Units; Registering A Handset To A Base Unit - Panasonic KX-TG8200FX Operating Instructions Manual

TG8200_8220FX(e-e).book Page 40 Monday, August 6, 2007 5:25 PM

Multi-unit Operation

Operating additional
units
Additional handsets
Up to 6 handsets can be registered to a
single base unit.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 4. If other model
handset is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
L Additional handsets will give you the
freedom to, for example, have an
intercom call with another handset
while a third handset is on an outside
call.
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when "Auto" is selected on
base unit selection (page 41), it will look
for another base unit to make or receive
calls. A base unit and the handsets it
communicates with is called a "radio
cell".
Note:
L Calls will be disconnected when the
handset moves from one radio cell to
another.
40
Registering a handset
to a base unit
The supplied handset and base unit are
pre-registered. When you purchase an
additional handset, refer to the additional
handset's installation manual for
registration. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), register
the handset.
1
" (centre of joystick) i N i
#
2
{^}/{V}: "Registration" i #
3
{^}/{V}: "Register H.set" i
#
4
{^}/{V}: Select a base unit number.
i #
L This number is used by the
handset as a reference only.
5
Proceed with the operation for your
model.
■ KX-TG8200/KX-TG8202
Press and hold {x} on the base
unit for about 5 seconds. (No
registration tone)
■ KX-TG8220
Press and hold {x} on the base
unit for about 5 seconds, until the
registration tone sounds.
L If all registered handsets start
ringing, press {x} to stop, then
repeat this step.
L After pressing {x}, the rest of this
procedure must be completed
within 90 seconds.
6
Wait until "Enter Base PIN" is
displayed. i Enter the base unit
PIN (default: "0000"). i #