Panasonic PT-AT5000E Operating Instructions Manual page 43

1) Adjust [FULL SCAN(Y)] / [SINGLE LINE
SCAN(Y)].
Set on [PICTURE] and use the
z
adjust [BRIGHTNESS] and then [CONTRAST].
Adjust the bottom line of the
waveform to 0 %
[BRIGHTNESS]
(0 or 7.5 IRE)
z
Adjust the top line of the
waveform to 100 %
[CONTRAST]
(100 IRE)
z
2) Adjust [FULL SCAN(R)] / [SINGLE LINE
SCAN(R)].
Set on [ADVANCED MENU] and use the
z
buttons to adjust [BRIGHTNESS R] and then
[CONTRAST R].
Adjust the bottom line of the
waveform to 0 %
[BRIGHTNESS R]
(0 or 7.5 IRE)
z
Adjust the top line of the
waveform to 100 %
[CONTRAST R]
(100 IRE)
z
3) Adjust [FULL SCAN(G)] / [SINGLE LINE
SCAN(G)].
Set on [ADVANCED MENU] and use the
z
buttons to adjust [BRIGHTNESS G] and then
[CONTRAST G].
Adjust the bottom line of the
waveform to 0 %
[BRIGHTNESS G]
(0 or 7.5 IRE)
z
Adjust the top line of the
waveform to 100 %
[CONTRAST G]
(100 IRE)
z
buttons to
Setting range:
−32 to +32
Setting range:
−64 to +64
Setting range:
−16 to +16
Setting range:
−32 to +32
Setting range:
−16 to +16
Setting range:
−32 to +32
[PICTURE] menu
4) Adjust [FULL SCAN(B)] / [SINGLE LINE
SCAN(B)].
Set on [ADVANCED MENU] and use the
z
buttons to adjust [BRIGHTNESS B] and then
[CONTRAST B].
Adjust the bottom line of the
waveform to 0 %
[BRIGHTNESS B]
(0 or 7.5 IRE)
z
Adjust the top line of the
waveform to 100 %
[CONTRAST B]
(100 IRE)
z
Note
When a 3D signal is being input (including converting
z
2D to 3D), the [WAVEFORM MONITOR] cannot be
executed.
Setting range:
−16 to +16
Setting range:
−32 to +32
ENGLISH - 43