Table of Contents
Advertisement
Base station power consumption
In standby mode
– Handset in charging cradle
– Handset out of charging cradle
During a call
General specifications
DECT standard
GAP standard
Range
Base station power supply
Environmental conditions
in operation
Care
Wipe the base station, charging cradle and hand-
set with a damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth. This can cause static.
Contact with liquid
If the handset has come into contact with liquid:
1. Switch off the handset and remove the bat-
tery pack immediately.
2. Allow the liquid to drain from the handset.
3. Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours (not in a microwave, oven etc.).
4. Do not switch on the handset again until it is
completely dry.
When it has fully dried out, you will normally be
able to use it again.
AL140
AL145
approx.
approx.
1.0 W
1.2 W
approx.
approx.
0.8 W
1.0 W
approx.
approx.
1.0 W
1.2 W
is supported
is supported
up to 300 m outdoors
up to 50 m indoors
230 V ~/50 Hz
+5° C to +45 °C;
20% to 75% humidity
!
9
Questions and answers
If you have any questions about using your phone,
visit us at www.gigaset.com/customercare at any
time. The table below contains a list of common
problems and possible solutions.
Problem
Cause
Nothing
The handset is not
appears in
turned on.
the display.
Battery pack is
flat.
No reaction
The keypad lock is
to key press.
activated.
No wireless
The handset is
connection to
outside the range
the base sta-
of the base sta-
tion, Base
tion.
flashes in
The handset is not
the display.
registered.
The base station is
not turned on.
Cords not routed
correctly.
You cannot
The phone cord
hear a ringer/
supplied has not
dialling tone
been used or has
from the fixed
been replaced by
network.
a new cord with
the wrong jack
connections.
Error tone
You have entered
sounds after
the wrong system
system PIN
PIN.
prompt.
PIN forgotten.
Solution
Press the end call key
a
for approx. 5 sec-
onds or place the
handset in the base
station.
Charge/replace the
battery pack (page 3).
R
Press the hash key
for approx. 2 sec-
onds (page 1).
Move the handset
closer to the base
station.
Register the handset
(page 3).
Check the power con-
nector at the base sta-
tion (page 2).
Check cord routing
(page 2).
Please always use the
phone cord supplied
or ensure that the jack
connections are cor-
rect when purchasing
from a retailer
(page 2).
Reset the system PIN
to the default 0000.
To do this, unplug the
mains unit from the
£
mains socket
Press and hold the
£
paging key
Plug the mains
£
adapter in again
Hold the paging
key down for at least
another 2 seconds
and then release.
The reset procedure is
now carried out.
The handsets are de-
registered. The calls
list is cleared.
Hide quick links:
Advertisement
Table of Contents
