Table of Contents
Advertisement
Troubleshooting
11.3 When a function does not work, check here
If you still have difficulties after following the instructions in this section, reset the unit. Disconnect the
mains lead and turn OFF the handset. Reconnect the mains lead and turn ON the handset.
11.3.1 Initial settings
Problem
I cannot hear a dial tone.
The unit does not ring.
11.3.2 General
Problem
The unit displays "CHECK
PAPER" even though
paper is inserted.
The other party complains
they only hear a fax tone
and cannot talk.
The {REDIAL} / {PAUSE}
button does not function
properly.
During programming, I
cannot enter the code or
ID number.
The ink film runs out
quickly.
The base unit beeps.
The speakerphone is not
working.
Cause & Solution
L If you use a splitter to connect the unit, remove the splitter and
connect the unit to the wall socket directly. If the unit operates
properly, check the splitter.
L Disconnect the unit from the telephone line and connect a known
working telephone. If the working telephone operates properly,
contact our service personnel to have the unit repaired. If the
working telephone does not operate properly, contact your
telephone company.
L The mains lead or telephone line cord is not connected. Check the
connections.
L If you connected the fax machine through a computer modem,
connect the fax machine directly to a telephone line socket.
L The ringer volume is turned OFF. Adjust it (page 24).
Cause & Solution
L The paper is inserted halfway. Insert it correctly (page 19) and
press {START} to clear the message.
L FAX ONLY mode is set. Tell the other party the number is only used
for faxes.
L Change the receiving mode to TAM/FAX mode (page 57), TEL
mode (page 55) or TEL/FAX mode (page 56).
L If this button is pressed during dialling, a pause will be inserted. If
pressed immediately after a dial tone is obtained, the last number
dialled will be redialled.
L All or part of the numbers are the same as another code or ID.
Change the number:
– remote operation ID: feature #11 on page 68.
– fax activation code: feature #41 on page 70.
L The help printing function, copy function, and reports also use ink
film.
L Even if there are only a few sentences, every page that comes out
of the machine is considered a full page.
L Turn OFF the following features:
– sending report: feature #04 on page 68.
– journal report: feature #22 on page 69.
– Caller ID list: feature #26 on page 69.
L Recording paper/ink film has run out. Press {STOP} to stop the
beeps and install paper/ink film.
L Use the speakerphone in a quiet room.
L If you have difficulty hearing the other party, adjust the volume.
11. Help
91
Advertisement
Table of Contents
