Table of Contents
Advertisement
Initial Programming
3.7 Date and time
You must set the date and time for both the
handset and the base unit.
Times are set independently and may not
necessarily be identical.
L The other party's fax machine will print the
date and time on each page you send
according to your base unit's date and time
setting.
L The accuracy of the clock is approximately
±60 seconds a month.
3.7.1 With the handset
{j/OK}
{<}{>}
Important:
L Confirm that the mains lead of the base
unit is connected.
L Ensure that w is not flashing.
L If a power failure occurs, set the date and
time for the handset again.
1
Press {j/OK}.
2
Select "Handset Setup", then press {>}.
3
Select "Time Settings", then press {>}.
4
Select "Set Date & Time", then press
{>}.
L The cursor (|) will appear on the display.
5
Enter the current date/month/year by
selecting 2 digits for each.
Example: 10 August, 2005
Press {1}{0} {0}{8} {0}{5}.
6
Enter the current hour/minute by selecting 2
digits for each. Press {*} repeatedly to
select "AM", "PM", or 24-hour time entry.
7
8
To correct a mistake
Press {<} or {>} to move the cursor to the
incorrect number, and make the correction.
Note:
{ih}
@
Example: 3:15 PM (12-hour time entry)
1. Press {0}{3} {1}{5}.
2. Press {*} repeatedly to display "PM".
Press {j/OK}.
Press {ih}.
L The date and time on the handset will be lost
after a power failure and must be reset, but
the base unit has backup to keep the time.
3. Preparation
@
@
25
Advertisement
Table of Contents
