Vcr Mode; Playing Back; Finding A Scene You Want To Play Back; Adjusting The Sound Volume - Panasonic NV-GS50EN Operating Instructions Manual

VCR Mode

Playing Back

The recorded scene can be played back
immediately after the recording.
1
Rotate the [OFF/ON/MODE] Switch
(43)
and set the Movie Camera to
the VCR Mode.
≥The [VCR] Lamp
(43)
(45)
CAMERA
VCR
CARD
PB
2
Press the [6] Button
the tape.
SEARCH
(7)
≥Rewind the tape to the point where
you want to start playback.
≥When the tape reaches the
beginning, rewinding stops
automatically.
3
Press the [1] Button
playback.
≥The [!] Indication appears.
(8)
BACK
LIGHT
To Stop Playback
Press the [∫] Button
(12)
FADE
ª Adjusting the Sound Volume
Until the [VOLUME] Indication appears,
keep pressing the [PUSH] Dial
Then, turn the [PUSH] Dial to adjust the
volume. After the adjustment, press the
VCR Mode
(45) lights up.
(7) to rewind
(8) to start
(12) .
(38)
.
[PUSH] Dial to make the [VOLUME]
Indication disappear.
(38)
WB/SHUTTER/IRIS/
MF/VOL/JOG
To adjust the volume with the Remote
Controller, press the [T] or [W] Button to
display the [VOLUME] Indication. Press
the [T] Button to increase the volume or
press the [W] Button to decrease the
volume. The [VOLUME] Indication goes
off a few seconds after the adjustment is
finished.
≥The sound volume cannot be adjusted
using the Remote Controller in
Playback Zoom Mode. (
≥If a cassette recorded with a copyright
protection signal is played back, the
picture is distorted by mosaic-like
patterns.
≥For other notes concerning this item,
see .
-124-
Finding a Scene You Want to
Play Back
ª Cue/Review Playback
BACK
SEARCH
LIGHT
(7)
If the [5] Button
(7)
is pressed during Playback, it turns to
Cue Playback A or Review Playback B.
A
≥If the Button is held continuously, it
turns to Cue Playback or Review
Playback until you release it.
-94-
PUSH
)
-97-
SEARCH
(9)
(9) or [6] Button
B