The Remote Controller - Panasonic NV-GS50EN Operating Instructions Manual

The Remote Controller

ª Inserting a Button-type Battery
Before using the Remote Controller,
insert the supplied button-type battery.
1
While pressing the Stopper 1, pull
out the Battery Holder.
1
2
Insert the button-type battery with
the (i) marking facing upward.
3
Insert the Battery Holder into the
Remote Controller.
≥When the button-type battery is
exhausted, replace it with a new
CR2025 battery. (A battery is normally
expected to last about 1 year.
However, it depends on operation
frequency.)
≥Make sure to match the poles correctly
when inserting the battery.
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace only
with the same or equivalent type
recommended by the equipment
manufacturer. Discard used batteries
according to manufacturer's
instructions.
WARNING
Risk of fire, explosion and burns. Do
not recharge, disassemble, heat
above 100xC or incinerate. Keep the
Button-Type battery out of the reach
of children. Never put Button-Type
battery in mouth. If swallowed call
your doctor.
Before Use
ª Using the Remote Controller
1
Direct the Remote Controller to the
Remote Control Sensor
Movie Camera and press an
appropriate button.
15˚
≥Distance from the Movie Camera:
Within approximately 5 metres
≥Angle: Within approximately 15o in
the vertical and horizontal directions
from the central axis
≥The above operative ranges are for
indoor use. Outdoors or under strong
light, the Movie Camera may not
operate properly even within the above
ranges.
≥Within a 1-metre range, you can also
use the Remote Controller on the LCD
Monitor side of the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used
simultaneously, they can be operated
individually by selecting different Remote
Controller Modes.
≥If the Remote Controller Mode of the
Movie Camera and that of the Remote
Controller do not match, [REMOTE]
Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the
[OTHER FUNCTIONS] Sub-Menu to the
desired Remote Controller Mode. (
Setup on the Remote Controller:
2
[VCR1]:
Press the [D] Button and [∫]
Button simultaneously. 1
[VCR2]:
Press the [E] Button and [∫]
Button simultaneously. 2
≥When the battery in the Remote
Controller is replaced, the mode is
automatically reset to [VCR1] Mode.
-71-
(35)
15˚
(35)
15˚
15˚
T
W
6 1 5
STILL ADV PAUSE STILL ADV
E ; D
INDEX STOP INDEX
K L
∫
SELECT
of the
)
-78-
1