Midas HERITAGE 2000 Operator's Manual page 43

The stereo output "b" C/O switch
disconnects the stereo local monitor
outputs from the main "a" outputs and
re-routes them to the secondary "b"
outputs.
The PHASE switch reverses the phase of
the left hand monitor signal.
When the left/right reverse is ON the left
hand monitor signals are routed onto the
right channel output speakers and the
right hand monitor signal are routed onto
the left channel output speakers.
The LEFT switch routes left hand
monitor signal to both the left and right
local monitor speaker outputs.
The left MUTE switch controls the mute
function on the left hand side of the
stereo local monitor speaker outputs.
The SOLO PFL switch sends the mono
PFL solo bus signals to the headphones
and local monitor outputs in place of the
stereo AFL solo bus signals.
The SOLO ON / CLEAR switch and
indicator has two functions; it illuminates
when any solo switch is active and when
pressed it clears any active solo switches.
The MONITOR fader gives continuous
adjustment of all three local monitor
output levels from + 10dB to off.
stereo output
output 'b'
C/O
O MONO
sum
left only
ON
PAD
l-r reverse
-20dB
R
L
mute mute
add mode
SOLO
pre fade
SOLO
(pfl)
solo clear
10 10
5 5
0 0
5 5
10 10
20 20
30 30
40 40
dB dB
monitor
MIDAS HS0031
The MONO sum switch adds the left and
right monitor signals with a 4.5dB
summing loss.
The -20 PAD switch acts on all three local
monitor outputs causing them to dim by
20dB. This function is also activated
whenever the talk system is in use to
prevent howl round.
The RIGHT switch routes right hand
monitor signal to both the left and right
local monitor speaker outputs.
The right MUTE switch controls the mute
function on the right hand side of the
stereo local monitor speaker outputs.
The SOLO ADD MODE switch allows
multiple channel access to the solo busses.
When the solo add mode is off the action
of pressing a solo switch will cancel any
previously active solo. Multiple solos
such as stereo left and right signals can
be monitored in this mode of operation as
long as the solo switches are pressed at
approximately the same time. When the
solo add mode is on the auto cancelling is
defeated which allows multiple channel or
output soloing. In this mode input solos
have priority over output solos and VCA
solos and will temporarily override them.
When the input solo is cancelled the
output solos or VCA solos will return.
31