Midas HERITAGE 2000 Operator's Manual page 35

The VCA switches assign the aux output
to VCA control from VCA masters 9
and 10.
The INS switches connect the aux insert
return signals to the aux mixes.
The mute SAFE switches remove the aux
mutes from snapshot automation.
The SPLIT switch changes the aux AFL
solos from mono to stereo.
The AUX faders give continuous
adjustment of the aux output levels from
+ 10dB to off.
9
9
vca
10
10
TALK TALK
INS INS
mute mute
SAFE SAFE
split
SOLO
solo solo
10
5
0
5
10
20
30
40
dB
aux
HS0051
MIDAS
The TALK switches connect the aux
mixes to the MONITOR module.
When the TALK INTERNAL or
GENERATOR INTERNAL are active
on the MONITOR module the
oscillator, pink noise and talk mic can
be routed into the aux mixes.
The aux MUTE switches mute the aux
signals at all points after the insert send.
The switches can be controlled from
snapshot automation.
The SOLO switches send aux signals
to the PFL mono and AFL stereo
busses. If a SOLO switch is pressed
for a short time it will latch on or off,
but, if it is held on for more than 1
second the latching is disabled and
when the switch is released the
channel solo will turn off. As a default
the solo system is auto cancelling so
each new solo cancels the last. This
function is time dependant which
allows several solos to be active as
long as they are switched on at
approximately the same time, i.e. to
solo both sides of a stereo mix press
both solo switches at the same time.
Alternatively the SOLO ADD MODE
switch on the MONITOR module can
be used to defeat the auto cancelling
and allow multiple channel
monitoring. In this mode input channel
solos have priority over the aux solos
and will temporarily override them.
When the input solos are cancelled
the aux solos will be active again.
23