Technics SX-KN2400 Operating Instructions Manual page 16

15_Part X.fm 166 ページ ２００３年２月５日 水曜日 午後１時５５分
Part X
ENVELOPE
Specify how the volume changes over time, from
the time the key is played to the time the sound
dies out.
1.
Use the PAGE buttons to view the 2/3 display.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select a tone.
• Use the L and M buttons to select a setting
∧
item and then the
selection.
3.
Adjust the settings for the volume envelope.
• Use the buttons below the display to set the
corresponding values. The envelope is cre-
ated on the display as you input the settings.
• Use the SUSTAIN PEDAL
select the type of sustain.
LONG:
Extend the release time of the sound.
HOLD:
Maintain the key-pressed condition.
4.
Repeat steps 2 and 3 for the other tones, as
desired.
166
QQTG0692
∨
and buttons to specify a
∧ ∨
and buttons to
ENVELOPE TOUCH & KEY FOLLOW
Specify how the volume changes relative to
touch or note pitch over time.
1.
Use the PAGE buttons to view the 3/3 display.
2.
Use the buttons to the left of the display to
select a tone.
• Use the L and M buttons to select a setting
∧ ∨
item and then the and
selection.
3.
Change the touch settings.
• Use the TOUCH ATTACK
specify the ATTACK time change depending
on touch. Use the TOUCH DECAY
buttons to specify the DECAY time change
depending on touch.
• At a − setting, the softer the keys are pressed,
the greater the change. At a + setting, the
harder the keys are pressed, the greater the
change.
4.
Change the key follow settings for the
ATTACK, DECAY and RELEASE.
• Use the RANGE buttons to specify the key-
board range.
Sound Edit
buttons to specify a
∧ ∨
and buttons to
∧ ∨
and