Store A Chord Progression - Technics SX-KN2400 Operating Instructions Manual

09_Part IV.fm 88 ページ ２００３年２月５日 水曜日 午後１時３４分
Part IV

Store a chord progression

Store the chord progression for the AUTO PLAY CHORD in the track for the CHORD part. Then, when
the AUTO PLAY CHORD is used during playback, even if you do not specify the chords with your left
hand, the chords change automatically.
• The chord length is specified with the CHORD STEP RECORD keys on the keyboard.
DELETE
e
&
Note value keys
Whole note
w
. Dotted half-note
h
Half-note
h
. Dotted quarter-note
q
Quarter-note
q
Eighth-note
e
Reset key
Press to begin storing from the begin-
&
ning.
Example of storing a chord progression
Measure 1 2
C C
w w
1.
On the SEQ MENU display, use the SONG
∧ ∨
SELECT and
number. Then select RECORD & EDIT.
2.
On the RECORD & EDIT display, select STEP
RECORD.
• The display changes to the PART SELECT
display.
3.
Using the balance buttons below the display,
select the track to which the CHORD (CHD/
APC) part has been assigned.
• The display changes to the STEP RECORD:
CHORD input display similar to the following.
88
QQTG0692
q q . h h . w
3 4
Am F D7 G7
h h h h
buttons to select the song
Correction keys
Move back one step.
Move forward one step.
Repeat key
Press to end the chord-storing proce-
dure and to specify automatic repeat
playback of the stored progression.
End key
Press after the whole chord progres-
sion has been stored.
DELETE key
Press to erase data.
DELETE
• To erase all the data from the current track,
while pressing the DELETE key, press the
End key ( ).
• STEP REC: CHORD can also be enabled by
pressing on the EASY RECORD button con-
tinuously a few seconds. This will display the
CHORD screen.
4.
Store the chords.
<Measure 1, measure 2>
While playing a C chord with your left hand,
press the key one time with your right hand.
w
• A "beep" tone indicates that the chord has
been successfully stored.
• The dot on the display where the chord is
∗
stored changes to a
automatically moves forward, in accordance
with the specified note value, to the next unre-
corded position. The chord name is shown on
the display.
Sequencer
w
mark and the cursor