Error Messages - Technics SX-KN2400 Operating Instructions Manual

19_Initialize.fm 191 ページ ２００３年１月２７日 月曜日 午後１時５６分

Error messages

No.
The data on the disk that you are
00
using is for a different product.
An error has occurred while the disk
01 was loading.
Please try again!
02 There is no disk in the Disk Drive.
03 The file that you tried to load is empty.
An error has occurred while the disk
05 was saving.
Please try again!
The disk that you are using is write
protected.
06
Please remove the write protection
and try again.
The disk that you are using is full.
07
Please use another disk.
An error has occurred while the disk
was formatting. The disk that you are
08
using may be faulty.
Please try formatting another disk.
10 The data is already copy protected.
The song you are trying to save is
15
empty.
This STANDARD MIDI FILE is incom-
16 patible with this instrument and cannot
be loaded.
17 This is not a STANDARD MIDI FILE.
The timebase (PPQ resolution) that
18 you tried
24/48/96/192/288/384 PPQ.
A problem has occurred with your
SEQUENCER Data.
20
This might be due to a damaged or
faulty disk.
21 Memory full
It is necessary to press REC STOP to
22
complete this procedure.
It is impossible to change the time sig-
23 nature because it has already been
set in the existing tracks.
A rhythm track already exists. It is
24 impossible to assign two tracks to
rhythm.
It is only possible to change the veloc-
25
ity on a melody track.
It is only possible to merge melody
tracks.
26
Tracks such as rhythm, chord and
control cannot be merged.
Contents
to load is not
No. Contents
It is only possible to copy melody
tracks.
27
Tracks such as rhythm, chord and
control cannot be copied.
This song is too long to be saved as a
28
MIDI file.
The MIDI file that you have tried to
load exceeds the memory capacity of
29 this instrument and cannot be played.
The SEQUENCER memory has been
cleared.
It is not possible to change the time
signature of a COMPOSER pattern
30 after it has been recorded.
If you want to proceed, you must first
clear the entire COMPOSER pattern.
The time signature of the pattern from
which you are copying is different from
the COMPOSER memory that you are
using.
31
Either: Change the time signature of
the COMPOSER memory
or: Copy from a pattern that has
the same time signature
32 Memory full
Select a Track before setting parame-
33
ters for AUTO PUNCH RECORD.
The file that you are trying to load was
saved on a previous KN keyboard. It is
43
only possible to load using the "PER-
FORMANCE" option.
It is impossible to edit a Drum Kit.
Please select a different sound from
44
any group except Keyboard Percus-
sion.
It is only possible to insert MELODY
Tracks. Tracks such as RHYTHM,
46
CHORD and CONTROL cannot be
inserted.
This procedure is not possible with a
47 composer pattern or the metronome.
Please select a preset rhythm pattern.
It is not possible to record using preset
banks, compile banks, or control
54
banks. Please select one of the user
banks.
Special tracks such
(APC), RHY and CTL exist in the song
55 from which you are copying and are
incompatible with the destination song
because it is in the GM mode.
as CHORD
191
QQTG0692