Technics SX-KN2400 Operating Instructions Manual page 120

08_Part III.fm 69 ページ ２００３年２月５日 水曜日 午後１時３１分
Part III
SEQ TO PAD COPY
1.
Record a phrase in the SEQUENCER, or load
data from a disk.
• After this procedure, please do not change the
song number.
• For details about SEQUENCER operation,
refer to page 73.
• For information about loading data, refer to
pages 120, 133.
2.
Press the PROGRAM MENUS button to turn it
on.
3.
Select PERFORMANCE PADS.
4.
Select SEQ TO PAD COPY.
• The display looks similar to the following.
5.
Select the measures of SEQUENCER data
you wish to copy from.
• On the SEQUENCER side, use the buttons to
make the corresponding settings.
FIRST MEASURE:
The first measure of the phrase you wish to
copy.
LAST MEASURE:
The last measure of the phrase you wish to
copy.
TRANSPOSE:
The setting to transpose the chords when
they are copied.
• The maximum that can be copied is 16 mea-
sures.
• When copying to pad button 5 or 6, the chord
(STEP) track is automatically displayed, and
the chord data is also copied. However, when
chord data from step record input does not
exist, the measures are blank.
• If you wish to convert the chords during play-
back, set TRANSPOSE to the key of C and
then copy the phrase.
6.
Select the pad button you wish to copy to.
• On the PERFORMANCE PAD side, use the
buttons to make the corresponding settings.
USER BANK:
The name of the bank (A/B/C).
PAD:
Pad button number (1 to 6).
PART:
The part to copy to.
TRACK:
The track number to copy from.
7.
Press the OK button.
• A confirmation display appears. Press the
YES button if you wish to copy the phrase, or
press the NO button to cancel the procedure.
8.
When you have completed the procedure,
press the PROGRAM MENUS button to turn it
off.
Peformance Pads
69
QQTG0692