Technics SX-KN2400 Operating Instructions Manual page 150

09_Part IV.fm 99 ページ ２００３年２月５日 水曜日 午後１時３４分
Part IV
MEASURE ERASE
Erase the recorded contents of specific mea-
sures. You can also specify which type of data is
to be erased.
• Note that only the contents of the measures
are erased, not the measures themselves; the
length of the performance remains the same.
∧
1.
Use the TRACK
the track number.
• This function does not work for the RHYTHM
part or CHORD part in which a repeat com-
mand has been stored.
• If ALL is selected, data is erased from the
specified measures of all the tracks at one
time.
2.
Use the FIRST MEAS
specify the start point (measure number).
3.
Use the LAST MEAS
ify the end point (measure number).
4.
Use the ERASE DATA
specify the type of data to be erased.
ALL:
All data is erased.
NOTE:
Only note data is erased.
CONTROL:
Only control data (volume, effect and other
panel settings as well as selection changes)
is erased.
5.
Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
∨
and buttons to specify
∧ ∨
and buttons to
∧ ∨
and buttons to spec-
∧ ∨
and buttons to
MEASURE DELETE
Delete specified measures from a track.
• The length of the performance accordingly
decreases by the number of deleted mea-
sures.
∧ ∨
1.
Use the TRACK and
track from which measures are to be deleted.
• This function does not work for the CHORD or
RHYTHM track in which the repeat function
has been stored.
• If ALL is selected, the specified measures are
deleted from all the tracks at one time.
2.
Use the FIRST MEAS
specify the first measure to delete.
3.
Use the LAST MEAS
specify the last measure to delete.
4.
Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
Sequencer
buttons to select the
∧ ∨
and buttons, to
∧ ∨
and buttons to
99
QQTG0692