Technics SX-KN2400 Operating Instructions Manual page 136

09_Part IV.fm 85 ページ ２００３年２月５日 水曜日 午後１時３４分
Part IV
6.
During playback, press the PUNCH IN button
at the point you want to begin recording.
• Recording begins as soon as the PUNCH IN
button is pressed. Begin playing at this point.
• The REC indication changes to the PUNCH
indication.
• The PUNCH IN button switches to the REC
STOP button.
7.
Press the REC STOP button at the point you
want to stop recording.
• Punch recording stops immediately.
• You can also begin punch-in recording by
playing the keyboard.
• You can specify the punch-in/punch-out points
with the optional Foot Switch (sold sepa-
rately). (Refer to page 172.)
AUTO PUNCH RECORD
You can also set the punch-in and punch-out
points beforehand, so that recording automati-
cally begins and ends at the specified points.
1.
On the PUNCH RECORD display, press the
AUTO: OFF button.
• The display looks similar to the following.
2.
Use the FIRST MEASURE
specify the number of the punch-in measure.
3.
Use the LAST MEASURE
specify the number of the punch-out measure.
• The number of the LAST measure must be
higher than the number of the FIRST mea-
sure.
• The specified measure is recorded.
4.
Use the COUNT IN MEASURE
tons to specify the number of lead-in mea-
sures you wish to have played back before the
punch-in measure.
• Set the metronome to on or off with the ON or
OFF button.
5.
Press the EXIT button.
• The display changes to the PUNCH RECORD
display.
6.
• Playback begins from the measure indicated
• Pertinent information, such as the FIRST
7.
• The mode changes automatically to the
• To discontinue punch recording in the middle,
∧ ∨
and buttons to
∧ ∨
and buttons to
∧ ∨
and but-
Press the START/STOP button.
by CURRENT MEASURE on the display.
MEASURE, is shown in the upper section of
the display.
Correct the performance.
recording mode at the specified FIRST mea-
sure. Begin playing at this point. The mode
automatically changes back to the playback
mode at the specified LAST measure.
press the CANCEL button. In this case, the
recorded contents up to that point are erased.
Sequencer
85
QQTG0692