Chapter 3 - Using The Quick Check 890 Verifier System; Scanning A Barcode Symbol Using The Qc890 Verifier; Scanning A Barcode Symbol Using Quick Check Imagedata - Hand Held Products Quick Check ImageData Barcode Verifier Quick Check 890 User Manual

3
Using the Quick Check 890 Verifier
System

Scanning a Barcode Symbol Using the QC890 Verifier

Calibration is a requirement of the ISO/IEC standards. Without
!
proper initial calibration, the values displayed may not be accurate.
Please be sure to calibrate the QC890 Verifier prior to scanning
barcodes and when you change apertures and/or external scanning
devices.
1. Place the QC890 Verifier on top of the symbol.
2. Press the scan button on top of the unit to turn on illumination. Look through
the unit's window to align the unit with the barcode.
Note: The best verification data is gathered by aligning the center of the symbol
to the center arrows.
3. Press the scan button on top of the unit again while the illumination is on to
scan and verify the barcode.
4. To scan PDF417 barcodes, hold the scan button down and move the verifier
up and down so the aiming line sweeps from the top of the bar code to the
bottom, and back up. This ensures that the entire code is scanned.
Scanning a Barcode Symbol Using Quick Check
ImageData
1. Place the QC890 Verifier on top of the symbol.
2. If necessary, press the scan button on top of the unit to turn on illumination to
aid in alignment of the symbol.
3. For the PC version, click the Scan button on the Main Display window.
Quick Check® 890 User's Guide 3 - 1