Table of Contents
Advertisement
8. Quick Check Maintenance
Battery Charging
Charging the battery pack > > when the batteries require recharging, the LOW
BATTERY!! Prompt will flash on the LCD. The unit will not allow further scans
until it has been turned off and the batteries recharge to a level above the
operational minimum. The batteries will only recharge when the Quick Check is
not in use.
To charge the batteries in the unit:
1.
Plug the QC charger into the power jack on the end of the Quick Check.
2.
Plug the AC charger power cube into an appropriate VAC wall outlet.
3.
Charge the batteries for a minimum of six (6) hours.
After following the proper battery charging time, your Quick Check will be ready
for operation.
Scanner Tip Cleaning
Occasionally the scanner tip and its optically clear window may become partially
obstructed by ink, paper fibers or other deposits. To insure reliable scanning,
you should check the tip periodically and clean it if dirty.
To clean the scanner tip:
1.
With the Quick Check turned off, lightly dust the tip with a soft camel's
hairbrush or equally soft device.
2.
If ink or deposits are still evident, using a mild cleaning solution and soft
applicator (cotton swab), wipe the tip to clean.
NOTE: Damaged wand tips may be replaced. Contact the Customer
Administration or Service Department for details.
Reflectance Calibration Page Replacement
The Reflectance Calibration Page that comes with your Quick Check
used for setting the unit's reflection calibration point. This page is a precision
made standard. If it should become physically damaged or dirty, it should be
replaced in order to insure proper operation of the unit. Contact Customer
Administration at Hand Held Products to order replacements.
®
200 is
37
Advertisement
Table of Contents
Troubleshooting
