Enabling Qcid For Bluetooth - Hand Held Products Quick Check ImageData Barcode Verifier Quick Check 890 User Manual

You will be asked if you need a passkey to add your device. The default passkey
for all Hand Held Products QC890 verifiers is "1234."
The Wizard loads the QC890 Verifier information into your device. You may click
a checkbox to indicate the QC890 Verifier is the default device to which Quick
Check ImageData connects.
Once you select Finish, your device is ready to communicate with the QC890
Verifier via the assigned ports. Make a note of the assigned port number. You
will need to know this port number in the following installation steps.

Enabling QCID for Bluetooth

1. Once you open the QCID application, click on File -> Preferences.
2. Choose the assigned incoming port number reported in the Add Bluetooth
Device wizard and click OK.
3. Your QC890 Verifier connects to the QCID application.
2 - 6 Quick Check® 890 User's Guide