illumination will turn off. If the calibration process is successful, the following
screen displays:
4. Enter your name and the location where the calibration was performed and
click on OK. The following screen displays:
5. If the unit does not calibrate, contact Hand Held Products Technical Support
(see
Technical Assistance
To access calibration logs, go to Settings->Calibration->Calibration Log.
Enter the password visions07.
Scanning Properly Using a Pen/Mouse Wand
Note: It is important to perform reflectance calibration prior to using any pen or
mouse wand. See
3-4.
1. Turn on the verifier and confirm that the pen/mouse wand is securely
connected.
2. Hold the pen wand as you would a pen or pencil, placing your fingers on
each side of the foot near the tip:
Quick Check® 890 User's Guide
on page 5-1).
"Calibrating an External Pen/Mouse Wand" on page
or
3 - 3