Honeywell 4600g User Manual page 100

When Check Character is set to Validate, but Don't Transmit, the unit only
reads Code 39 barcodes printed with a check character, but will not transmit the
check character with the scanned data.
When Check Character is set to Validate and Transmit, the imager only reads
Code 39 barcodes printed with a check character, and will transmit this charac-
ter at the end of the scanned data. Default = No Check Character.
* No Check Character
Validate, but Don't Transmit
Validate and Transmit
Code 39 Message Length
Scan the barcodes below to change the message length. Refer to Message
Length Description (page 7-2) for additional information. Minimum and
Maximum lengths = 0-48. Minimum Default = 0, Maximum Default = 48.
Minimum Message Length
Maximum Message Length
Code 39 Append
This function allows the imager to append the data from several Code 39 bar-
codes together before transmitting them to the host computer. When this func-
tion is enabled, the imager stores those Code 39 barcodes that start with a
space (excluding the start and stop symbols), and does not immediately trans-
mit the data. The imager stores the data in the order in which the barcodes are
read, deleting the first space from each. The imager transmits the appended
data when it reads a Code 39 barcode that starts with a character other than a
space. Default = Off.
On
* Off
7 - 6