Chapter 14 - Maintenance; Repairs; Cleaning The Device; Inspecting Cords And Connectors - Honeywell 4600g User Manual

14
Maintenance

Repairs

Repairs and/or upgrades are not to be performed on this product. These ser-
vices are to be performed only by an authorized service center. See
"Customer Support" on page 15-1 for further information.
Maintenance
Your imager provides reliable and efficient operation with a minimum of care.
Although specific maintenance is not required, the following periodic checks
ensure dependable imager operation:

Cleaning the Device

Reading performance may degrade if the imager's window is not clean. If the
window is visibly dirty, or if the imager isn't operating well, clean the window with
a soft cloth or lens tissue dampened with water (or a mild detergent- water
solution). If a detergent solution is used, rinse with a clean lens tissue dampened
with water only.
The imager's housing may also be cleaned the same way.
!
Caution:
Do not submerge the imager in water. Do not use
abrasive wipes or tissues on the imager's window –
abrasive wipes may scratch the window.
Never use solvents (e.g., acetone, benzene, ether, or
phenol-based agents) on the housing or window –
solvents may damage the finish or the window.

Inspecting Cords and Connectors

Inspect the imager's interface cable and connector for wear or other signs of
damage. A badly worn cable or damaged connector may interfere with imager
operation. Contact your Honeywell distributor for information about cable
replacement. Cable replacement instructions are on page 14-2.
14 - 1