Connecting The Imager With Usb - Honeywell 4600g User Manual

Connecting the Imager with USB

Note: See "Imager Models"
your imager.
An imager can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the imager first, then to the com-
puter.
2. Program the imager for a USB interface using the Plug and Play barcodes
beginning on
3. The imager beeps.
4. Verify the imager operation by scanning a barcode from the
Symbols in the back of this manual.
For additional USB programming and technical information, refer to "USB Appli-
cation Note," available at
on page 1-2 to determine which interfaces apply to
page 1-9.
www.honeywell.com/aidc.
Sample
1 - 5