Scan Stand Symbol; Presentation Mode - Honeywell 4600g User Manual

When a unit is in Scan Stand mode, it remains idle as long as it sees the Scan
Stand symbol. (See
is presented, the imager is triggered to read the new code.
Note: The imager automatically adjusts the illumination LEDs to the lowest light
level possible to maintain a good lock on the Scan Stand symbol. When
a symbol is presented, the imager's light levels adjust to the saved setting
(see LED Power Level
of ambient light to operate correctly.

Scan Stand Symbol

When a unit is in Scan Stand mode, the LEDs shine at the Scan Stand symbol
on the base of the stand which tells it to remain idle. When the Scan Stand
symbol is covered, the imager turns the LEDs on at the configured power level
(Default High) and attempts to find and decode barcodes in its field of view.

Presentation Mode

Note: The operation of light bar off-axis illumination units and non-light bar units
differs slightly. When a light bar unit is in Presentation Mode and idle, the
illumination LEDs go dim, but never go out. When a non-light bar unit is
in Presentation Mode and idle, the illumination LEDs will go out
completely.
This programs the imager to work in Presentation mode. The LEDs are either
off or at the lowest power for ambient conditions until a barcode is presented to
the imager. Then the LEDs turn on automatically to read the code. Presenta-
tion Mode uses ambient light to detect the barcodes. If the light level in the
room is not high enough, Presentation Mode may not work properly.
3 - 6
Scan Stand Symbol
on page 3-9). This mode requires at least 50 lux
Scan Stand Mode
Scan Stand Symbol
Presentation Mode
on page 3-6.) When a different code