Output Sequence Example - Hand Held Products IMAGETEAM 5620 System Manual

Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Required
* Off

Output Sequence Example

In this example, you are scanning Code 93, Code 128, and Code 39 bar codes,
but you want the scanner to output Code 39 1st, Code 128 2nd, and Code 93
3rd, as shown below.
Note: Code 93 must be enabled to use this example.
You would set up the sequence editor with the following command line:
SEQBLK62999941FF6A999942FF69999943FF
The breakdown of the command line is shown below:
SEQBLKsequence editor start command
62 code identifier for Code 39
9999 code length that must match for Code 39, 9999 = all lengths
3 - 10
A - Code 39
B - Code 128
C - Code 93
IMAGETEAM™ 2020/5620 System Manual
On/Not Required