Connecting The Base With Usb - Hand Held Products IMAGETEAM 5620 System Manual

Connecting the Base with USB

A base can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the base and to the computer.
2. Program the base for the USB interface by scanning the appropriate
programming bar code.
3. Verify the base operation by scanning a bar code from the
in the back of this manual.
For additional USB programming and technical information, refer to Hand Held
Products "USB Application Note," available at
Note: Without using the 9-volt external, power supply, the base only uses
enough power from the host to operate the interface. The scanner's
battery is not charged when in this mode. Using the 9-volt, external power
supply allows the scanner's battery to be charged, and no power is drawn
from the host.
1 - 24
www.handheld.com
IMAGETEAM™ 2020/5620 System Manual
Sample Symbols
.