Base Charge Mode - Hand Held Products IMAGETEAM 5620 System Manual

Base Charge Mode

In order for the battery to be charged, there must be enough voltage for the
circuitry to work. There are three conditions during which power can be supplied
to the base:
Condition 1:
Condition 2:
Condition 3:
The chart below describes each selection by condition.
Automatic
Full Charge Rate
Low Charge Rate
Battery Charge Off
Using a slow charge rate draws less current (power) from the input power source
when the battery is mostly discharged.
Scan the appropriate bar code for your application. Default = Automatic .
* Automatic
Low Charge Rate
IMAGETEAM™ 2020/5620 System Manual
9VDC power supply connected to the barrel connector
12VDC host power source only
5VDC host power source only
Condition 1
Fast Charge
Fast Charge
Slow Charge
No Charge
Condition 2
Slow Charge
Fast Charge
Slow Charge
No Charge
Full Charge Rate
Battery Charge Off
Condition 3
No Charge
No Charge
No Charge
No Charge
1 - 5