Table of Contents
Advertisement
Example:
If you have two bar codes next to one another and the centering
window is set to 40% left edge and 60% right edge, only the bar
code that intersects that window will be decoded.
20%
10%
0%
Output Sequence Overview
Require Output Sequence
When turned off, the bar code data will be output to the host as the scanner
decodes it. When turned on, all output data must conform to an edited sequence
or the scanner will not transmit the output data to the host device.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Output Sequence Editor
This programming selection allows you to program the scanner to output data
(when scanning more than one symbol) in whatever order your application
requires, regardless of the order in which the bar codes are scanned. Reading
the Default Sequence symbol programs the scanner to the Universal values,
shown below. These are the defaults. Be certain you want to delete or clear all
formats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you'll need to know the code
I.D., code length, and character match(es) your application requires. Use
the Alphanumeric symbols (inside back cover) to read these options.
To Add an Output Sequence
1. Scan the Enter Sequence symbol (see
2. Code I.D.
On the
Symbology Chart
to apply the output sequence format. Locate the Hex value for that symbol-
ogy and scan the 2 digit hex value from the
back cover of this manual.
3 - 8
Decoded bar code
40%
30%
on page A-1, find the symbology to which you want
IMAGETEAM™ 2020/5620 System Manual
60%
70%
Multiple
Symbols, page 3-12).
Programming Chart
80%
90%
100%
inside the
Advertisement
Table of Contents
