Changing Scanner Name - Via Bar Codes - Hand Held Products IMAGETEAM 5620 System Manual

Changing Scanner Name - via Bar Codes

If you wanted set up your scanners with names 0001-0007, you may scan the
bar codes below. Scan the Reset bar code after each name change and wait for
the scanner to re-link to the base before scanning the next bar code to name the
next scanner.
Alternatively, you may change the name with a bar code command if you cannot
send serial commands to the base. One way to do this is to scan the bar code
below and scan a number for the scanner name. For example, if you had 7
scanners to one base, scan the bar code below with the first scanner, scan the
1 bar code on the
scan Save. Then scan the Reset bar code and wait for the scanner to re-link to
the base before scanning the next bar code. Repeat that process for scanner
number 2 , 3, 4 etc.
If you want to assign an alphabetic name to the scanner, create a Code 128 bar
code containing "~BT_NAM name ." followed by a FNC3 character (hexidecimal
83), where name is the new scanner name. Scan the Reset bar code (page 1-9
or on the Programming Chart
use Barcode Builder, which is included with Quick*View. You may download
Quick*View from the Hand Held Products website:
IMAGETEAM™ 2020/5620 System Manual
0001
0003
0005
0007
Programming Chart
Scanner Name
inside the back cover of this manual). You may
inside the back cover of this manual and
www.handheld.com
0002 0002
0004
0006
Reset
.
1 - 9