Table of Contents
Advertisement
Spot Monitor
Dwell Time: You can set the channel sequence
l
time to 2 SEC, 5 SEC, 10 SEC, 20 SEC, 30 SEC,
40 SEC, 50 SEC, 60 SEC, 70 SEC, 80 SEC or 90
SEC.
Event Popup: Displays an event popup on the
l
spot monitor if motion, sensor or all (motion or sen-
sor) occur.
Event Settings
Sensor
In: Displays the number of the SENSOR-IN termi-
l
nal.
Sensor Type: The sensor state can be set to
l
either N.O. (Normally Open) or N.C. (Normally
Closed).
Camera: Select the connected camera channel to
l
the SENSOR-IN terminal.
Alarm Out: Select the alarm (relay) output number
l
for the ALARM-OUT terminal for the output alarm
(relay) signal.
34
Motion
Channel: Select the channel to set motion detec-
l
tion.
Sensitivity: Set the level of sensitivity for the cre-
l
ated motion detection area. Sensitivity can be set
from level 01 to 10 or OFF.
Alarm Out: Select the number of the ALARM-OUT
l
terminal for the output alarm (relay) signal when
motion is detected.
Area: Select the desired motion detection area on
l
the preview window screen.
b / B / v / V: Moves the yellow cell box to
-
another cell zone.
-
ENTER: Selects or cancels the motion
detection area at the current cell position.
-
Press ESC to exit the settings.
Notes:
•
You can select the motion detection area by using
the mouse.
-
To select the area: Drag & drop a cell to the
right to select the motion detection area.
-
To cancel area: Drag & drop a cell point of
a selected cell area to the left to cancel the
motion detection area.
•
In the condition that illumination is low and the
outline of object is not clear enough to see,
regardless of sensitivity, Motion Event could be
possible not to happen. You must check Motion
Event before setting.
Advertisement
Table of Contents
