Table of Contents
Advertisement
38
Installation
•
Prealarm: Specify the pre-event recording time. When the Event
signal is detected, the DVR is recording the data before the
event during the setting time.
•
Postalarm: Specify the post-event recording time. When the
Event signal is detected, the DVR is recording the data after the
event during the setting time.
Instant/Panic
Settings concerning instant/panic recording.
3
•
Ch: Displays the channel number.
•
Resolution: Selects the recording resolution. The LE4000 series
models are display only.
•
Quality: Selects the recording picture quality
•
Frame Rate: Selects the frame rate. The frame rate is the number
of recorded frames per second. According to resolution, the
frame rate is set automatically.
Event settings
Sensor
•
In: Displays the number of the ALARM-IN terminal.
•
Sensor Type: The sensor state can be set to either N.O. (Normally
Open) or N.C. (Normally Closed).
•
Camera: Select the connected camera channel to the ALARM-IN
terminal.
•
Relay Output: Select the alarm (relay) output number for the
RELAY-OUT terminal for the output alarm (relay) signal.
•
Preset: Select the preset number. When the input is activated,
the camera moves to the selected preset position and the
picture of the camera in that position appears on the monitor.
Motion
•
Channel: Select the channel to set motion detection.
NOTE
If you set the channel name to Korean or Japanese, you should
set the system language to Korean or Japanese to display the
channel name correctly.
•
Sensitivity: Set the level of sensitivity for the created motion
detection area. Sensitivity can be set from level 01 to 10 or OFF.
Advertisement
Table of Contents
