Event Settings; Sensor; Motion; Notification - LG LRN8240D-NH Owner's Manual

36 Installation

Event settings

Sensor

3
• In: Displays the number of the ALARM-IN terminal.
• Sensor Type: The sensor state can be set to either N.O. (Normally
Open) or N.C. (Normally Closed).
• Camera: Select the camera channel connected to the ALARM-IN
terminal.
• Relay Output: Select the alarm (relay) output number for the
RELAY-OUT terminal for the output alarm (relay) signal.
• Preset: Select the preset number. When the input is activated,
the camera moves to the selected preset position and the
picture of the camera in that position appears on the monitor.

Motion

• Channel: Select the channel to set motion detection.
• Relay Output: Select the number of the RELAY-OUT terminal for
the output alarm (relay) signal when motion is detected.

Notification

Marks up when you want to activate the selected option. If the
selected notification option is activated, the device will notify the
user about the information of selected option by E-mail.
• Sensor On: Sends an e-mail when a sensor has occurred.
• Motion Detection: Sends an e-mail when a motion detection
has occurred.
• Admin Password Changed: Sends an e-mail when the
administrator password has been changed.
• Power On/Off: Sends an e-mail when power is on or off.
• Disk Full: Sends an e-mail when the HDD has fully recorded.

Mail

• Notification: Mark up to be notified the unit's operating
information according to notification settings by e-mail.
• SMTP Server: Enter the SMTP Server address.
If notification option is not mark up and the SMTP server option
is empty, the SMTP Port, User Name, Password and TLS options
cannot be set.
• SMTP Port: Enter the SMTP Port Number. Typically the port used
for SMTP is 25. However in some cases it is better to change this
port number for added flexibility or security. You can edit this
port between 1 and 65535.
• User Name: Enter the user name.
• Password: Enter the password.
• TLS: Mark up if you use the TLS (Transport Layer Security)
function.
• Mail Address (1 to 3): Enter the mail address.
You can input up to 3 e-mail addresses.
• Sender: Enter the sender.