Event Settings; Sensor; Motion - LG LRH7080D Series Owner's Manual

40 Installation

Event settings

Sensor

3
• In: Displays the number of the ALARM-IN terminal.
• Sensor Type: The sensor state can be set to either N.O. (Normally
Open) or N.C. (Normally Closed).
• Camera: Select the camera channel connected to the ALARM-IN
terminal.
• Relay Output: Select the alarm (relay) output number for the
RELAY-OUT terminal for the output alarm (relay) signal.
• Preset: Select the preset number. When the input is activated,
the camera moves to the selected preset position and the
picture of the camera in that position appears on the monitor.

Motion

• Channel: Select the channel to set motion detection.
• Sensitivity: Set the level of sensitivity for the created motion
detection area. Sensitivity can be set from level 1 to 10 or OFF.
• Relay Output: Select the number of the RELAY-OUT terminal for
the output alarm (relay) signal when motion is detected.
• Area: Select the desired motion detection area on the preview
window screen.
- w/s/a/d: Moves the yellow cell box to another cell
zone.
- OK: Selects or cancels the motion detection area at the
current cell position.
- Press BACK to exit the settings.
NOTE
• You can select the motion detection area by using the mouse.
- To select the area: Drag & drop a cell to the right to select
the motion detection area.
- To cancel area: Drag & drop a cell point of a selected cell
area to the left to cancel the motion detection area.
• In the condition that illumination is low and the outline of
object is not clear enough to see, regardless of sensitivity,
Motion Event may not happen. You must check Motion Event
before setting.